Another Workshop Improvement

Pensioner will probably be the only blipper to like this!

I just completed this auxiliary table for my drill press. The original table that it's bolted to is too small to be much use for woodworking. The new table is going to make it so much easier to use the tool, not only for drilling, but also for sanding.

I'm going to make a tray to fit in the opening under the table for storing the insert plates and sanding drums.

Now I can finish the spokeshave handle that I started in the class I went to a few weeks ago.

P.S. I encountered a problem late in the construction. The track on the right side of the table was slightly higher than the table surface -- the dado wasn't deep enough. I don't know how that happened, but it would have been extremely difficult to fix without my little shoulder plane that I bought months ago, and hadn't used until today. It is the exactly the same width as the dado. I knew I'd need it sooner or later!